工業除濕機如何調試？
將除濕機電源插入到電源插座，這是電源就接通電了。然后我們就可以找到除濕機的界面控制。
此時面板上有很多按鈕，這是我們先按下面板上的開關按鈕，將除濕機打開。
打開電源之后，此時除濕機就會開始工作，前面會有排風口出來，用于除濕。
面板上面，會顯示很多功能，濕度，代表的是室內空氣的濕度，除濕時，濕度會降低。
除濕機的使用條件是室溫15-30℃(也有15-35℃)；相對濕度在70%以上就可以開機使用了。
當相對濕度低于50%，這個時候就不必要使用除濕機了，因?yàn)橄鄬穸?0%已經是生產上比較合適的空氣濕度了，不會對工業生產造成影響，除非你的產品有特殊要求，需要將空氣濕度控制在50%以下,甚至更低，否則的話，只能是在浪費能源。
或者空氣露點溫度低于4℃，這個時候也不宜使用，在這樣時候，空氣濕度也基本很低了。
Plug the dehumidifier into the power socket first. Then we can find the interface control of the dehumidifier.
At this time, there are many buttons on the panel. We first press the switch button on the lower board to turn on the dehumidifier.
After the power is turned on, the dehumidifier will start working, and there will be an exhaust outlet in front for dehumidification.
Many functions will be displayed on the panel. Humidity represents the humidity of indoor air. During dehumidification, the humidity will be reduced.
The service condition of dehumidifier is room temperature 15-30 ℃ (also 15-35 ℃); When the relative humidity is more than 70%, it can be turned on and used.
When the relative humidity is lower than 50%, it is unnecessary to use the dehumidifier, because the relative humidity of 50% is the most appropriate air humidity in production and will not affect industrial production. Unless your product has special requirements and needs to control the air humidity below 50%, or even lower, it can only be a waste of energy.
Or the air dew point temperature is lower than 4 ℃, which is not suitable for use at this time. At this time, the air humidity is basically very low.
